|
Option Mitre
cross cut table
Anodised aluminium for up to 46° tilt in both directions, with
LCD display 0.01°; micro-adjustment for cutting angle, 0° locked
positiom.
For accurate, precise angle cuts in small or large panels
or framing – without any additional accessories. This concept
always provides a sufficiently large support for your workpieces – exactly
where you need it. You can release the lock with a single motion
and adjust the table to ± 46,50° using the LCD display.
Further details include the sturdy 0° clamp and the micro adjustment
for easily adjusting the table in increments of 1/100°. The “RadioCompens” system
greatly expands the capabilities of the mitre cross-cut table by
means of radio-controlled, automatic length compensation and bus
connection of the table to the control. Thus set-up times for mitre
cuts can be reduced by more than 80%. The cutting-length read-outs
on the cross-cut fence immediately show the correct length. You merely
need to set the table to the desired cutting angle – the electronics
will do everything else for you.
Note: Supplied in lieu of the standard
cross cut table. |
|
T74
Classic
